How to service the temperature blend door actuator on 2002 Lincoln Blackwood?

The first step to service the temperature blend door actuator is uninstalling the floor duct. The removal begins by disconnecting the connector from the electronic actuator followed by screw removal and finally pulling down the actuator shaft until the electronic actuator can be taken out. The installation procedure includes doing the removal steps in reverse order.

OEM 2002 Lincoln Blackwood Blend Door Actuator

Air Blend Door Actuator

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blend Door Actuator found

View related parts
2002 Lincoln Blackwood Motor Assembly Part Number: XL3Z-19E616-AB
Product Specifications
- Other Name: HVAC Heater Blend Door Actuator; HVAC Blend Door Actuator; Blower Motor; Actuator
- Base No.: 19E616
- Item Weight: 0.60 Pounds
- Item Dimensions: 8.7 x 7.7 x 7.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XL3Z-19E616-AB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2002 Lincoln Blackwood Submodels:
- Base | 8 Cyl 5.4 L GAS

2002 Lincoln Blackwood Blend Door Actuator

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2002 Lincoln Blackwood Blend Door Actuator available at FordPartsDeal.com. You can confidently purchase our OEM 2002 Lincoln Blackwood Blend Door Actuator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2002 Lincoln Blackwood Blend Door Actuator Parts Q&A

Q: How to service the temperature blend door actuator on 2002 Lincoln Blackwood?
A: The first step to service the temperature blend door actuator is uninstalling the floor duct. The removal begins by disconnecting the connector from the electronic actuator followed by screw removal and finally pulling down the actuator shaft until the electronic actuator can be taken out. The installation procedure includes doing the removal steps in reverse order.